Komatsu — 5.18.1. CHECKING THE OIL LEVEL

SECTION 5 MAINTENANCE Page 48 TIRES AND RIMS UNDERINFLATION To little air pressure increases deflection, causes the tire to wipe and scuff over the road, results in extra strain on the tire and increases the chance of bruising. OVERINFLATION Overinflation reduces the tire deflection and the tire contact area causing the tire to ride on the crown and results in rapid wear in the center of the tread. CHANGING WARNING! Tire and rim repairs must be done by specially trained persons using special safety tools. An improperly repaired tire or rim can separate suddenly and cause serious injury. Wheel rim components should be checked for damage and cracks.

Damaged parts must be replaced, NOT repaired. Disassembly of tubeless tire of this size is very difficult. Therefore, do not replace parts yourself. Contact Construction Equipment Authorized Distributor or tire distributor where persons with special training and safety tools are available. WHEEL RIM MOUNTING Torque the bolts to their special torque value 920 [Nm] or 870 [Nm] for 1[”] and M24x3 respectively. Fig. 5.40. Wheel Mounting Hardware 5.18. TRANSMISSION SYSTEM 5.18.1. CHECKING THE OIL LEVEL WARNING! When it is necessary to make any checks or adjustments with the engine running, use two people.

A trained operator must be at the controls to safeguard the mechanic making the checks or adjustments. Be sure the transmission direction lever is locked in neutral (N), the frame halves are locked together and the parking brake is applied. 1. Park the machine on level ground. 2. Lock the transmission in "N" (neutral), lower the bucket to the ground and apply the parking brake. 3. Check the oil level in lower sight gauge (2, Fig. 5.41) through a cut-out in the rear frame left wall. OM515C520C99/1E DRESSTA