MAINTENANCE SECTION 5 Page 49 TRANSMISSION SYSTEM HIGH LOW Fig. 5.41. Checking the Transmission Oil Level Fig. 5.42. Upper Sight Gauge 1. Upper Sight Gauge 2. Lower Sight Gauge 3. Filler Plug 4. If the oil level is too low, stop the engine, lock the frame locking bar, remove oil filter cap (3, Fig. 5.41) and add oil. 5. Start the engine and let it run at low idle. 6. Check the oil level in both sight gauges through the cut-out in the frame (Fig. 5.41). If the oil level is not between the high and low mark (Fig. 5.42) on the top sight gauge, remove filler cap (3, Fig.
5.41) and add oil until the level settles in the middle of the upper gauge (maximal level should not exceed the middle of the upper gauge). Refer to Chart 2 and 3 to choose the proper oil grade. When refilled reinstall the cap. IMPORTANT: If the oil level is above the upper sight gauge, drain the oil until the level is in the middle of it. Too much oil in the transmission will cause aeration of the oil. WARNING! Protect your eyes and hands while draining hot oil. 5.18.2. CHANGING THE OIL 1. With the oil at the operating temperature, park the machine on level ground. Lower the bucket to the ground, apply the parking brake and stop the engine. 2. Install the frame locking bar. WARNING!
Wear hand and eye protection when draining hot fluids. 3. Remove drain plug (1, Fig. 5.43) from the transmission while the oil is still warm. 4. Unscrew transmission oil filler cap (2, Fig. 5.41). This will vent the case and allow the oil to drain faster. 5. While the oil is draining, service the transmission pressure filter element. Refer to Par. 5.18.3. 6. Service the transmission suction strainer. Refer to Par. 5.18.4. DRESSTA OM515C520C99/1E