Komatsu — 5.18.3. CHANGING THE TRANMISSION PRESSURE FILTER

MAINTENANCE SECTION 5 Page 51 TRANSMISSION SYSTEM 3 2 1 Fig. 5.44. Transmission Oil Pressure Filters Fig. 5.44A. Transmission Oil Pressure Filters 1. Center Bolt 2. O-Ring 3. Drain Plug 4. Washer 5. O-Ring 6. Case 7. Spring 8. Gasket 9. Element 10. O-Ring 11. Filter Header 12. O-Ring 13. Plug 1. Filter Element 2. O-Ring 3. Filter Head Machines in CE version are equipped with a pressure filter shown in Fig. 5.44A. The element should be replaced also when the transmission filter warning light starts glowing. If this happens carry out as follows: 1. Remove element (1) from filter head (3) by turning it couterclockwise. 2. Remove O-ring (2). Check its condition.

If it shows any signs of wear or deterioration, replace it. 3. Install O-ring (2). 4. Coat the seal contact area of new element (1) with engine oil or chassis grease. 5. Install the new element by turning it clockwise in the head till it contacts filter head (4). 6. Make aligning marks on the filter and the filter head and then give the filter an additional 1 to 1.5 turns. DRESSTA OM515C520C99/1E