Komatsu — 3.1.1. GENERAL

MACHINE TRANSPORT AND STORAGE SECTION 3 Page 3 3.1. MACHINE TRANSPORT 3.1.1. GENERAL WARNING! During transportation of a machine the front and rear frame should be blocked by means of a special locking bar and interlocking pins. A frame locking bar and two pins (Fig. 3.1 and Fig. 3.2) - in the stowed position are provided on the LH side of a loader. They are used to lock the front and rear frame of a loader to prevent accidental frame turning during service and lifting on lifting slings. METHOD OF LOCKING OF FRONT AND REAR FRAME OF LOADER Prior to operating of the machine, place the locking bar in the stowed position as shown in Fig. 3.1.

Repair or replace the frame locking bar and pins if damaged or lost to ensure frame locking, (Fig. 3.2). Fig. 3.1. Frame Locking Bar and Pins in stowed position Fig. 3.2. Frame Locking Bar and Pins in locked position Fig. 3.1.A. Frame Locking Bar and Pins in stowed position (CE version) Fig. 3.2.A. Frame Locking Bar and Pins in locked position (CE version) DRESSTA OM515C520C99/1E