Komatsu — 3.1.1. GENERAL

SECTION 3 MACHINE TRANSPORT AND STORAGE Page 4 MACHINE TRANSPORT Always tie down securely a machine for transport to prevent movement. WARNING! When transporting a machine be especially careful during loading and unloading. Use low gear range and low speed. Load and unload the machine on even surface that makes full support for the machine and transport facility. Block the transport facility so that it cannot move. Make use of loading platform of sufficient strength, small approach angle and appropriate height. 1. Clean clay, oil and other slippery material of the loader tires. 2. The hydraulic, cooling and braking system should be filled up. 3. The fuel tank should be filled with app.

10 [l] of fuel. 4. The parking brake should be applied. The pressure in the tires should conform to this instruction, see "TIRES”, Section 6. 5. The batteries should be fully charged, the electric system master switch turned off. 6. The starting switch should be in the neutral position and the key removed. IMPORTANT ! When transporting this machine on a high speed carrier or railaway car, seal the exhaust pipe and air intake openinings to prevent turbocharger damage. REAR LAMPS Fig. 3.3. Rear Lamps 1. Bracket 2. Bolt 3. Hole The rear lamps are mounted on pivotable brackets (1, Fig. 3.3). The lights positioned as shown in the drawing above, conform to the traffic regulations.

To change the rear lights position: 1. Unscrew and remove bolt (2). 2. Turn bracket (1) into the required position. 3. Reinstall the bolt in hole (3) and tighten. IMPORTANT: It is recommended to change the position of lamps (to fold brackets) before machine transport to prevent damage. OM515C520C99/1E DRESSTA