Komatsu — 3.3. MOVING A DISABLED MACHINE

SECTION 3 MACHINE TRANSPORT AND STORAGE Page 6 LIFTING ON SLINGS Fig. 3.4A. Method of Handling 520C Loader by a Crane (for machine equipped with 20.5R25 Tires and 2.29 [m 3 ] bucket) 1. Frame Locking Bar Machine’s weight Q = 10800 [kG] 3.3. MOVING A DISABLED MACHINE Towing this machine is not recommended. To move a disabled machine, use a trailer or low-boy truck if possible. If towing is necessary, such as freeing a stuck machine, tow it only as far as necessary. Towing machine backwards is recommended. When towing, the engine must be running (if operative) to enable turning and braking of the machine. Towing of machines equipped with ground driven system is easier.

Prior to towing release spring parking brake (refer to "PARKING BRAKE”, Section 5) and unlock frames by placing locking bar in the stowed position as shown in Fig. 3.1 and 3.1A. WARNING: When pulling with a chain or cable, take up the slack slowly to avoid jerking. A chain or cable which fails under load can whip and cause serious injury. Stand clear. Do not pull or tow unless the operator's compartment is guarded against or out of reach of a whipping chain or cable. WARNING: Observe safety precautions specified in this manual. Refer to "SAFETY PRECAUTIONS”, Section 2. Hook a towing line or cable of adequate strength to the towing lug. The towing load should not exceed a force of 80 [kN].

OM515C520C99/1E DRESSTA