Komatsu — 3.4.1. PREPARING FOR STORAGE

SECTION 3 MACHINE TRANSPORT AND STORAGE Page 8 MACHINE STORAGE 9. It is recommended to use fuel stabilizer in quantity specified by the manufacturer. Stabilizer will prevent degrading of fuel, sludge buildup, and stop the growth of bacteria in fuel during storage. Fuel stabilizer may be purchased from: FUEL PREP 1000 NALCO CHEMICAL COMPANY 2901 BUTTERFIELD ROAD OAK BROOK, ILLINOIS 60521, USA or Machine Distributor WARNING: Corrosion inhibitors are volatile and flammable. Use them only in a well-ventilated area. Keep flames and sparks away. DO NOT SMOKE. Store a container in a cool, well-ventilated place. WARNING:

Avoid prolonged exposure to volatile corrosion inhibitors because eye and skin irritation may occur. 10. It is recommended to use volatile corrosion inhibitor (VCI) in a fuel tank. VCI provides corrosion protection by contact with metal, and in a closed system, the vapors provide sufficient protection for areas that are not in contact with fuel. When using VCI per HMS B00- 0006 pour 120 [ml] of volatile corrosion inhibitor for each 100 [l] of total fuel capacity. VCI may be purchased from: NOX RUST VCI #105 OIL DAUBERT CHEMICAL COMPANY 1200 JORIES BLVD. OAK BROOK, ILLINOIS 60521, USA or Machine Distributor 11. Deaerate the fuel system. Refer to "FUEL SYSTEM”, Section 5. 12.

Start the engine and run idle at half throttle for 3 minutes and then stop the engine. 13. Lubricate all points of the machine as outlined in the "SERVICE GUIDE", Section 5. IMPORTANT: Be sure to oil or grease all linkage connections, joints, nuts, pins, shafts, and bushings not covered in the "SERVICE GUIDE". 14. Drain the engine oil, replace the engine oil filters and fill them with proper grade of oil. Refer to ENGINE, Section 5. 15. Add 15 [ml] VCI for each liter of engine oil to the crankcase. (example: if the total capacity of a crankcase is 10 [l] add 150 [ml] VCI). 16. Start the engine and run it idle at half throttle for 30 seconds and then stop the engine. 17.

Remove the air precleaner. 18. Seal all external openings (i.e. engine exhaust outlet, filler caps, breathers, etc.) with tape wide enough to cover the opening, regardless of its size. NOTE: When sealing with tape, be sure to extend tape approximately one inch (25 [mm]) beyond an opening to insure good sealing. 19. Pour 60 [ml] VCI to the intake manifold to prevent corrosion of the space between piston and the bottom part of the engine head. OM515C520C99/1E DRESSTA