Komatsu — 3.4.2. SERVICING DURING STORAGE

MACHINE TRANSPORT AND STORAGE SECTION 3 Page 9 MACHINE STORAGE 20. It is recommended to pour 50 [ml] VCI type 1 oil per HMS B00-0006 Standard to the hydraulic reservoir. 21. Remove the batteries and place them on wooden skids. Then store them in a cool, clean, dry, well-ventilated place away from areas provided for storing or dispensing fuel and oil, not near any heat source and preferably where the temperature range is between 0 [ ° C] to +21 [ ° C] . Be sure the batteries are fully charged. IMPORTANT: Do not place battery on a concrete floor or in temperature below 0 [ ° C]. IMPORTANT:

If the machine is stored with dry charged batteries or no batteries, the alternator output lead (+) must be disconnected and insulated. Failure to do so may result in permanent damage to the alternator. 22. If the bucket is detached for storage, secure the cylinder piston rod to the machine to avoid damage. 23. Coat all machined and unpainted surfaces with chassis grease to prevent rust. It is recommended to use AKORIN N-2 grease. 24. If it is desirable to leave the tires on the machine, jack the machine up and place it on blocks leaving the tires in suspension. Deflate and cover the tires. Tires should not be exposed to direct sunlight or any fuel or solvent vapors. WARNING:

Use extra caution when jacking up the machine. Jacking up the machine can be hazardous if performed improperly. Use jacking equipment of sufficient capacity. Be sure the jacking points are strong enough to support the machine. Be sure the jack is stable and well supported. Before jacking up the machine, block the tires which will not be lifted. Lock the frame halves together with the locking bar and pins. If the rear tires are being lifted, block the rear axle to prevent it from pivoting unexpectedly. DO NOT run the engine with the machine on jacks. 3.4.2. SERVICING DURING STORAGE ONE-MONTH REPETITIVE SERVICE PERIOD Be sure the batteries are fully charged.

Never allow batteries to run down below 3/4 full charge. WARNING: DO NOT charge batteries in a closed area. Provide proper ventilation to guard against explosion of an accumulation of the gas given off in the charging process. SIX-MONTH REPETITIVE SERVICE PERIOD 1. Visually inspect the engine and radiator for leakage and other defects. Correct all defects, consult Authorized Construction Equipment Distributor if necessary. 2. Remove all seals from the machine ports: crank-case and hydraulic breather plugs, engine air intake, fuel tank vent lines, etc. 3. Install fully charged batteries. Refer to "BATTERIES", Section 5. WARNING:

Be sure the electrical system master switch is off when connecting or disconnecting batteries to minimize the chance of sparks and explosion. DRESSTA OM515C520C99/1E