Komatsu — 3.4.3. PREPARING FOR OPERATION AFTER STORAGE

SECTION 3 MACHINE TRANSPORT AND STORAGE Page 10 MACHINE STORAGE WARNING: Check that batteries are level in the holders and securely held. The hold-down fasteners should hold the batteries firmly but not too tight to warp or damage either the hold-down bar or batteries. WARNING: Battery cables must be so arranged to enable easy removal of all pugs. Lay the cables so they do not chafe against the hold-down bar. Always connect the negative ground cable last to minimize the chance of sparks or an explosion. The electric system master switch must be in the OFF position and the key removed. 4. Check the coolant level in the radiator and add proper concentrations of antifreeze, if required.

Refer to "CHECKING COOLANT LEVEL”, Section 5. 5. Perform steps 7 thru 21 per item 3.4.1. 3.4.3. PREPARING FOR OPERATION AFTER STORAGE 1. Visually inspect the machine for external leakage and other defects. 2. Clean the radiator, refer to "CLEANING THE RADIATOR", Section 5. 3. Thoroughly clean the machine, being sure to rinse off any caustic residue. 4. Correct any defects found. Consult Authorized Construction Equipment Distributor if necessary. 5. If the machine was jacked up (refer to 3.4.1. item 24) inflate the tires to the normal operating inflation pressure. Refer to "TIRES", Section 6. 6. Remove all seals from the machine: filler plugs, breathers, engine air intake and exhaust, etc. 7.

Remove the air cleaner filter elements for cleaning or replacement. Refer to "AIR CLEANING SYSTEM", Section 5. 8. Remove and replace the fuel filters. Refer to "CHANGING THE OF FUEL FILTERS”, Section 5. 9. Fill the fuel tank with approved diesel fuel. Refer to "REFILL SPECIFICATIONS AND CAPACITIES", Section 5. 10. Lubricate all points of the machine as outlined in the "LUBRICATION", Section 5. IMPORTANT: Be sure to oil or grease all linkage connections, joints, nuts, pins, shafts, and bushings not covered in the "SCHEDULED MAINTENANCE GUIDE". 11. Change the engine oil and fuel filters. Refer to ENGINE, Section 5. WARNING:

Be sure the electrical system master switch is off when connecting or disconnecting batteries to minimize the chance of sparks or explosion. 12. Install fully charged batteries. Refer to "BATTERIES", Section 5. WARNING: Check that batteries are level in the holders and securely held. The hold-down fasteners should hold the batteries firmly but not too tight to warp or damage either the hold-down bar or batteries. Lay the cables so they do not chafe against the hold-down bar or the fasteners. OM515C520C99/1E DRESSTA