SECTION 4 OPERATING Page 10 INSTRUMENTS AND CONTROLS 12. Quickcoupling Solenoid Valve Switch 13. Tachometer or Speedometer 13A. Tachometer 13B. Rear Window Heating Switch 13C. Flash Light Switch 14. Voltmeter 15. Torque Converter Temperature Gauge 16. Service Brake Warning Light 17. Torque Converter Oil Temperature Warning Light 18. Ground Driven Steering Warning Light (If Equipped) 19. Warning Lights (If equipped) 20. 24 V Receptacle 21. Audible Alarm (Buzzer under the Instrument Panel) 22. Transmission Direction Lever Lock Switch 22A. RSM System Switch 1 . HOURMETER The hourmeter electrically records the actual hours of engine operation. It is activated when the engine is running.
It eliminates guess work when determining proper lubrication and maintenance periods. 2. ENGINE OIL PRESSURE WARNING LIGHT The light will come on when the engine oil pressure is too low. At the same time a buzzer will sound. IMPORTANT: When the light comes on, stop the engine immediately to prevent damage to the engine. Do not start the engine again until the problem has been corrected. 3. ENGINE COOLANT TEMPERATURE WARNING LIGHT The light will indicate when the coolant temperature exceeds the allowable limit. If the light comes on, maneuver the machine to the side and operate the engine at low idle. Do not shut the engine down.
If the light stays on, investigate the cause and take corrective action before operating the machine again. 4. PARKING BRAKE WARNING LIGHT The light will indicate if the parking brake is applied. At the same time a buzzer will sound. IMPORTANT: Release the parking brake before moving a machine. The brake could burn or be damaged if the machine is driven with the brake applied. 5. ENGINE COOLANT TEMPERATURE GAUGE The gauge pointer should remain within the green area equivalent to 71 to 93 [ ° C] temperature range. During normal loader operation the pointer readings may vary between the minimum and maximum limited by the green area of the gauge.
Continuous operation of the engine below the minimal temperature means insufficient engine lubrication. Too low coolant temperature causes excessive exhaust fumes and an increase in fuel consumption. If the ambient temperature is low it may be necessary to cover the radiator grill partly in order to keep the proper temp. of the coolant (the pointer should stay within the green area of the meter). The gauge pointer should also remain in the green area under full load conditions. If the temperature remains too high in spite of interruptions of engine operation, check the coolant level, the condition of the radiator, fan, water pump and thermostat. OM515C520C99/1E DRESSTA