Komatsu — 4.3. INSTRUMENTS AND CONTROLS

OPERATING SECTION 4 Page 11 INSTRUMENTS AND CONTROLS 6. FUEL GAUGE This gauge is electrically operated and indicates the available fuel supply in the fuel tank. The gauge is accurate only when the machine is level. 6A. TURN SIGNAL WARNING LIGHTS The lights start blinking when the turn signal switch is put on. 6B. ENGINE OIL PRESSURE GAUGE The gauge indicates engine oil pressure. 7. ETHER START BUTTON (if equipped) This switch injects a spray of ether to facilitate start of the engine in low air temperatures. Press the switch to release a measured shot of starting fluid into the engine. Refer to Section 4.11.2 for more information. IMPORTANT:

DO NOT use the ether injector when air temperature is above 0 [ ° C]. Follow the correct method for starting the engine. 8. INSTRUMENT PANEL ILLUMINATION LIGHT The light illuminates the lower part of the instrument panel with the starting switch when the parking lights are on. 9. STARTING SWITCH. Fig. 4.3. Starting Switch Positions The starting switch is used to connect and disconnect the circuits of the electric system and switching on and off the engine and is equipped with a key. Starting switch positions:

ACC – to the left – not used, OFF - after inserting the key- disconnects the electric circuits, RUN - to the right – activates the electric circuits, START- to the right with automatic return to RUN when released – engine startup, Midposition between RUN and START - warning lights check - activates all warning lights, IMPORTANT: Do not hold the key in START position for more than 30 second. Allow a 2–3 minute interval between cranking. Never place the key in START position when engine is running. DRESSTA OM515C520C99/1E