Komatsu — 4.3. INSTRUMENTS AND CONTROLS

OPERATING SECTION 4 Page 19 INSTRUMENTS AND CONTROLS 42. WINDSHIELD WASHER SWITCH This switch controls the windshield washer. Push the switch button down to run the washer. Release the button to stop the washer. Use the washer prior to switching on the wipers to protect the windshield from being scratched. 43. DEFROSTER FAN SWITCH This switch is used to control the air (hot or cold) supplied onto the windows of the cab. 44. REAR WINDOW WIPER CONTROL SWITCH (IF EQUIPPED) This switch controls the speed of the rear window wiper motors. It has three positions: OFF, LO, HI. Move the switch to the desired position for low or high speed wiper operation. 45.

REAR WINDOW WASHER SWITCH (IF EQUIPPED) This switch controls the rear window washers. Push the switch button down to run the washer. Release the button to stop the washer. Use the washer prior to switching on the wipers to protect the windshield from being scratched. 46. PARKING BRAKE LEVER (Fig. 4.10) The parking brake lever is located to the rear right of the operator’s seat on the floorboard. To apply the parking brake, pull the lever up. To release, lift the lever and depress the button, then lower the lever. Apply the parking brake before leaving the machine. It is recommended that the parking brake only be used to hold the machine after it has come to a stop.

However, should the brake system ever fail, the parking brake may be used to make an emergency stop. IMPORTANT: Release the parking brake before moving the machine. The brake could burn or be damaged if the machine is driven with it applied. 46 Fig. 4.10. Parking Brake Lever DRESSTA OM515C520C99/1E