SECTION 4 OPERATING Page 18 INSTRUMENTS AND CONTROLS 37. BUCKET AND BOOM PILOT CONTROL LEVER The lever controls raising and lowering as well as rollback and dumping operations of the bucket. Refer to Par. 4.17.1 and 4.17.3 for additional information. 38 39 40 41 42 43 44 45 Fig. 4.9. Side Control Panel 38. Fan Control Switch 39. Heater/Air Conditioner Temperature Control Knob 40. Main Switch 41. Windshield Wiper Switch 42. Windshield Washer Switch 43. Defroster Fan Switch 44. Rear Window Wiper Switch (if equipped) 45. Rear Window Washer Switch (if equipped) 38. FAN CONTROL SWITCH This switch controls the speed of the heater fan circulating air inside the cab. It has three positions: OFF, LO.
HI. Move the switch to the desired position. If the air outside is very dusty, switch the fan into “HI" position. This will create high pressure inside the cab, which will prevent dusty air from coming into the cab. 39. HEATER /AIR CONDITIONING TEMPERATURE CONTROL If lower temperature is required, turn the knob to the left. If higher temperature is required turn the knob to the right. 40. MAIN SWITCH It switches either the air conditioning or heating. It has three settings: neutral, heater, air conditioning WARNING! Switch off the defroster fan before adjusting the direction of flow to avoid injury. 41.
WINDSHIELD WIPER CONTROL SWITCH This switch controls the speed of the windshield wiper motor. It has three positions: OFF, LO, HI. Move the switch to the desired position for low or high speed wiper operation. OM515C520C99/1E DRESSTA