Komatsu — 4.11.1. NORMAL START (AMBIENT TEMPERATURE ABOVE 0 (C))

SECTION 4 OPERATING Page 28 4.10. DOME LIGHT WITH SWITCHES Dome light is installed in the roof of the cab on the right and left hand side of the operator’s head. The light is equipped with a switch. Two lights are installed on machines in CE version. 4.11. STARTING AND STOPPING THE ENGINE 4.11.1. NORMAL START (AMBIENT TEMPERATURE ABOVE 0 [ ° C]) WARNING: DO NOT jump on or off the machine. Keep two hands and one foot, or two feet and one hand in contact with the steps and hand holds at all times. Always face the machine when climbing on or off to reduce the chances of slipping and injury. 1. Check that the parking brake switch is applied (machine stopped) 2.

Check that transmission direction lever is locked in the "N" (neutral) position. 3. Turn the master electric system switch "ON" (Refer to Fig. 4.22, 4.22.A). 4. With your back against the back rest of the operator's seat, adjust the seat position so that the brake and decelerator pedal can be easily depressed (Refer to Fig. 4.6). 5. Sound the horn to clear the area of personnel. NOTE: All the warning lights should light up while the starting key is between RUN and START position. Replace any bulb that fails to light up. NOTE: The engine will not start while the direction lever is in any position other than "N" (neutral). Fig. 4.23. Starting and Stopping the Engine 1.

Transmission Direction Lever 2. Accelerator Pedal 3. Starting Switch 4. Parking Brake Lever 6. Turn the starting key from RUN to START position (Fig. 4.3) to start the engine with accelerator pedal released (idle speed). 7. Keep the key till the engine starts but no longer than 30 seconds. Then release the key immediately, it returns automatically to the RUN position. OM515C520C99/1E DRESSTA