SECTION 4 OPERATING Page 34 4.16. PARKING THE MACHINE WARNING!: When parking the machine observe the following rules: a) Park the machine in a non-traffic area. If parking in traffic lanes cannot be avoided, provide appropriate flags, barriers, flares, and warning signals. Also provide advance warning signals in the traffic lane for approaching traffic. b) Always lock the machine, including any anti-vandalism attachments, when leaving the machine unattended. C) Avoid parking on a slope, however, if parking on a hillside is necessary, park at the right angle to the hill and block the tires as shown in Fig. 4.27. NOTE:
Avoid parking the machine in puddles of oil, grease or gasoline because this damages the tires. Fig. 4.27. Hillside Parking NOTE: Park the machine on level ground to obtain accurate coolant, lubricant, hydraulic, fuel level checks. 4.17. LOADER OPERATIONS The loader equipment is hydraulically operated. When the bucket circuit is being operated, oil flow to the boom is cut off. IMPORTANT: Holding the control lever in any position except B "hold" and D “float" for an extended period of time after the hydraulic cylinder rod has reached the limit of its travel will produce excessive heat in the hydraulic system which may affect loader performance. 4.17.1. BOOM CONTROL LEVER POSITIONS (Fig.
4.28.) Fig. 4.28. Boom Control Lever Positions (Standard Version) A. Raise B. Hold C. Lower D. Float OM515C520C99/1E DRESSTA