Komatsu — 4.17.1. BOOM CONTROL LEVER POSITIONS

OPERATING SECTION 4 Page 35 LOADER OPERATIONS Fig. 4.29. Boom Control Lever Positions (Upgraded Version) A. Raise B. Hold C. Lower E. Bucket Rollback F. Bucket Dump P. Forward Direction of the Lever In standard version the boom control is located to the far right of the operator's seat. It has four positions: A, B, C, D (“raise", "hold", "lower", and "float"). In upgraded version, a single lever controlling both the boom and the bucket movement is located on the right of the operator’s seat. It has three positions for boom control: “raise", "hold", "lower", and three positions for bucket control: “rollback", "dump" and "hold". The hold position is common for both the bucket and the boom.

RAISE (A, Fig. 4.28, 4.29) To raise the boom assembly, pull the lever back as far as it will go. A solenoid latch in the valve locks the lever in detented position. The return to "HOLD" must be done manually or will be done automatically when the boom reaches the preset stopping height of the automatic boom kick-out. HOLD (B, Fig. 4.28, 4.29) The control lever, when not in a detented position, will automatically return to "HOLD" when released. The boom will remain stationary in this position. LOWER (C, Fig. 4.28, 4.29) Push the lever part way forward (in standard version) or all the way forward (in upgraded version) to lower the boom.

The lever will automatically return to "HOLD" when released. WARNING! Do not leave the machine with a raised boom. The boom may drop down even if the engine is shut down. (Refer to CHANGING THE HYDRAULIC SYSTEM OIL, Section 5.14.2). FLOAT (D, Fig. 4.28, FOR STANDARD VERSION) The boom assembly can be lowered at any time by moving the lever to C “lower" or D “float" position. Push the lever all the way forward for this position. This position is detented so the lever must be pulled back manually to the "hold" position. Use the “float" position to follow the contour of the ground when leveling or to lower the boom by gravity. DRESSTA OM515C520C99/1E