OPERATING SECTION 4 Page 39 LOADER OPERATIONS CLOSE Put the control lever back to close the bucket clam. When released, the lever will return to the "HOLD" position. When a machine is equipped with a multi-purpose bucket, it is also equipped with a clam position indicator. A clam opening product graphic (A, Fig. 4.33) is located on the upper left hand side of the bucket. This product graphic indicates to what extent the clam is opened or closed. "0" indicates closed, "2" indicated half open and "4" indicates a fully open clam. To set the multi-purpose bucket as a bucket, pull the control lever back until the clam indicator is at the "0" setting on the clam product graphic (A, Fig. 4.33).
Fig. 4.33. Multi-purpose Bucket set in "Bucket" Position. A. Clam Product Graphic To set the multi-purpose bucket as a scraper, open the clam until the indicator points to "2" or "4" on the clam product graphic (A, Fig. 4.34). The more the clam is open, the deeper a cut can be made. Fig. 4.34. Multi-purpose Bucket set in "Scraper" Position. A. Clam Product Graphic DRESSTA OM515C520C99/1E