OPERATING SECTION 4 Page 41 LOADER OPERATIONS To use the multi-purpose bucket as a clamshell, open the clam until the indicator is at the bottom or completely open (A, Fig. 4.37). Fig. 4.37. Multi-purpose Bucket set in "Clamshell" Position. A. Clam Product Graphic 4.18. LOADER TECHNIQUES Terrain, footing conditions, types of materials being worked and maneuvering space determine the speed at which the loader can function. When the bucket is at work, keep the engine speed at full throttle and operate in the first (1) gear transmission range. Use gear range two (2) and three (3) for traveling purposes. The techniques for using the loader as described below are not intended to be all inclusive.
Each work situation will vary. Loader operation may be altered for each particular application for its best efficiency. When possible, start all jobs from relatively level ground. If necessary, level an area large enough to provide sufficient working space. This prevents back and forth pitching of the loader and will result in easier operation. Avoid wheel spin whenever possible; this wastes effort and causes ruts and piles that pitch and tilt the loader. In cold weather, this material can freeze and cause additional difficulty the following day. 4.18.1. LOADING, TRANSPORTING AND PILING 1. When loading from a bank or stockpiling, use the V-method shown in Fig.
4.38, or the step loading method shown in Fig. 4.39. Keep the trucks close to the work area to minimize loader travel. Keep work areas clean and level. When possible, spot the next truck to be loaded on the opposite side as shown in Fig. 4.38. DRESSTA OM515C520C99/1E