Operating AutoPowr Transmission Setting AutoPowr Options C F H G B 1 2 3 E RXA0086590 —UN—09FEB06 A D A—Vehicle Settings Switch B—Command Dial C—Select Switch D—Display E—Position Off F—Position 1—PTO G—Position 2—Heavy Tillage H—Position 3—Transport or Light Tillage CommandCenter Display And AutoPowr Selector Settings NOTE: A Load Anticipation feature allows AutoPowr to predict how much “hydraulic load” the engine expects from the activation of the hitch or a particular SCV function. For this to be activated, the SCV or hitch lever is placed in the detented position when the “hydraulic load” is decreasing. AutoPowr remembers that load change.
When it detects the same lever starting movement in the opposite direction , it responds with a short engine rpm boost thus providing more power to better handle oncoming load increase. at 1817 engine rpm for 540 rpm PTO speed and at 2000 engine rpm for 1000 rpm PTO speed operation. Field Cruise can be used to limit engine speed. Auto/PTO Options English Translation (if applies) Low RPM Low RPM Med/Low RPM Med/Low RPM Med/High RPM Med/High RPM High RPM High RPM Press Settings Switch (A) to view menu items on display (D), rotate Command dial (B) to highlight Transmission Options and press SELECT switch (C). See AutoPowr Options table for a list of selections to choose from.
Using Command dial, highlight desired setting and press SELECT switch again. AutoPowr Options Auto with PTO Low RPM Auto no PTO Med/Low RPM Med/High RPM High RPM AutoPowr Options Both AUTO 2 (G) and AUTO 3 (H) are fuel economy settings. AUTO 2 is used in conjunction with switch position 2 to adjust minimum engine speed when operating with a light load. See Auto 2 Options table for a list of selections to choose from. The default engine rpm setting in AUTO 2 is 1500 rpm.
English Translation (if applies) Auto with PTO Auto with PTO Auto no PTO Auto no PTO Auto 2 Auto 2 Auto 3 Auto 3 Back Back AutoPowr Options Auto 2 1500 RPM 1600 RPM 1700 RPM Either AUTO with PTO or AUTOno PTO is used in conjunction with Position 1 (F) of the selector switch. Setting determines how much engine rpm ”pull down” to allow under load, before transmission automatically downshifts. See Auto/PTO Options table for a list of selections to choose from. See Engine Speeds—AutoPowr Options Auto With or Without PTO, for further information. 1800 RPM AUTO 3 is the same as AUTO 2, except it is used in conjunction with switch position 3.
See Auto 3 Options table for a list of selections to choose from. The default engine rpm setting in AUTO 3 is 1200 rpm. AutoPowr Options Auto 3 1200 RPM 1300 RPM NOTE: Using correct engine speed is very important for PTO operations. Refer to implement Operator’s Manual for specific implement speeds. Run engine 1400 RPM 1500 RPM Continued on next page OURX935,00004A4 1925AUG081/2 4213 122208 PN=110