Hitch Using Hitch Lever DisplaySetting Depth and Lock/Dampening I 12 % B F 56 12 Using Hitch Command Lever D A Lever movements within the proportional region (D and E), commands hitch to raise or lower. Raise or lower rate depends on how far the lever is moved from center position. Push lever down to lower hitch; pull lever up to raise hitch. Lever will not raise hitch above upper height limit, but will move hitch below the saved depth setting. A short duration of the lever into proportional region will change depth command by 1 or 2 counts.
C J 32 12 % M E L RXA0085778 —UN—09JAN06 G 44 12 % SET H N K % LOCK + Setting Depth Use lever to move hitch to desired operating depth, then press Depth Set Switch (M) to store in memory. Each time Depth Set Switch is pressed, the previous depth setting is erased and the current depth is saved as the new setting. Operating depth can be preset before field operation. Hold lever forward until depth command reaches desired value, then store by pressing Depth Set Switch.
A—Hitch Command Lever B—Hitch Raise—Slow C—Hitch Lower—Slow D—Hitch Raise—Fast E—Hitch Lower—Fast F—Detent Position, Raise G—Detent Position, Lower H—Float Position Hitch Above Stored Depth Setting J— Hitch Below Stored Depth Setting K—Hitch at Stored Depth Setting L—Current Depth Indicators M—Depth Set Switch N—Hitch Lock / Dampening Switch Display Hitch information appears in lower half of display when using hitch lever, or can be permanently displayed by selecting with the Command Dial. Current depth is represented by both a numeric value and indicator mark (L). The numeric value is also present on other hitch adjustment displays.
The saved depth setting is represented by a horizontal bar (K). Pressing Depth Set Switch (M) will move bar to align with indicator mark (L). Screens (I—K) show current depth above (I), below (J) and at stored depth (K). Vertical bar in the display shows the upper height limit setting. Continued on next page OURX935,0000017 1902JAN081/2 502 122208 PN=121