Hitch Detaching Implement from Walterscheid Couplers 1. Lower implement to the ground. NOTE: For tractors equipped with Independent Link Suspension induce tractor leveling with engine operating: Depress clutch Put transmission shift lever in gear for four seconds Move shift lever to NEUTRAL position Repeat until suspension is level RXA0098641 —UN—25AUG08 2. Disconnect hydraulic hoses and electrical connections. 3. Retract lower hooks and lower the hitch until couplers are clear of implement hitch pins. 4. Disconnect center link from implement. 5. Carefully drive tractor forward away from implement. A—Retaining Ring B—Link Handle C—Lock Retaining Link 6.
Lock center link into the transport position. Remove retaining ring (A). Lift center link handle (B) and lock retaining link (C) into position. OURX935,00003E7 1930JUL081/1 Attaching Implement to Quick Coupler B RXA0087968 —UN—21MAR06 RXA0086769 —UN—14FEB06 A—Coupler Latch Handle B—Hitch Control Lever CAUTION: To avoid bodily injury or machine damage, put transmission in PARK position and check the full range of hitch for interference, binding, or PTO separation whenever an implement is attached. 4. Raise hitch enough to engage implement pins in hooks. CAUTION: To avoid bodily injury or machine damage make sure implement is attached correctly.
Incorrect attachment can allow implement to be pulled over the tractor wheel and onto the operator station. Do not stand between tractor and implement. 1. Pull up on coupler latch handles (A). 5. Push coupler latch handles down to lock implement to quick coupler. 2. Lower hitch until quick coupler hooks are lower than implement hitch pins. 3. Back up tractor to implement. 6. Connect hydraulic hoses and electrical connections. Continued on next page OURX935,00003E8 1925AUG081/2 5015 122208 PN=134