John Deere Omar287594 — SCV Lever—Float Position

Hydraulics and Selective Control Valves SCV Lever—Extend and Extend Detent Position Extend Pull lever slightly to rear of neutral. This slowly extends cylinder at a variable flow rate. (See Adjusting SCV Flow Rate in this section.) RXA0080732 —UN—13MAY05 Pull the lever all the way rearward to extend the remote cylinder at maximum rate. Detent operation mode depends on the SCV detent selected. NOTE: Time setting is ignored in extend position. Extend Detent Pull lever rearward to "click" detent position and release. Lever will return to neutral position, but flow will continue at rate set on TouchSet panel. (See Adjusting SCV Flow Rate and Adjusting Timed Detent in this section.) NOTE:

If lever is not returned from detent to neutral in less than 0.8 seconds, detent cancels. Detent can be cancelled by moving SCV lever forward or rearward from neutral. Flow timing begins when lever is moved into detent. SCV flow time should be adjusted so cylinder will be fully extended when time has elapsed. OURX935,000045B ­19­03JAN08­1/1 SCV Lever—Retract and Retract Detent Position Retract Position RXA0080733 —UN—13MAY05 Push lever slightly forward of neutral. This slowly retracts cylinder at a variable flow rate. (See Adjusting SCV Flow Rate in this section.) Lever returns to neutral and flow stops when released.

Push the lever forward to the first detent notch to retract the remote cylinder at maximum rate. NOTE: Time setting is ignored in retract position. Detent can be cancelled by moving SCV lever slightly forward or rearward from neutral after lever has returned to neutral or by holding lever in retract position for more than 0.8 seconds after lever is released from detent. Retract Detent Position Push lever forward to "click" detent position and release. Lever will return to neutral position, but flow will continue at rate set on TouchSet panel. (See Adjusting SCV Flow Rate and Adjusting Timed Detent in this section.) NOTE:

Detent positions are ignored at start up until lever is cycled to NEUTRAL. Flow timing begins when SCV lever is first moved into detent. SCV flow time should be adjusted so cylinder will be fully retracted when time has elapsed. OURX935,000045C ­19­03JAN08­1/1 60­6 122208 PN=153