Hydraulics and Selective Control Valves SCV Lever—Float Position Push SCV lever all the way forward and down to lock in float position. Lever and SCV will remain in float position until lever is manually returned to neutral. Cylinder is free to extend or retract, letting implement follow ground contour. Float indicator (A) will be displayed when lever is in float position. RXA0080731 —UN—13MAY05 NOTE: Time setting is ignored in Float position. If lever is in float position at engine start up, float function will operate if lever was moved to float position at least 10 seconds before engine was stopped and had not moved out of float position.
If lever was not operated in this manner, float function will be disabled until lever is cycled to neutral. Cycle cylinder fully in both directions after being used in the float position to insure cylinder is filled with oil. A—Float Indicator A RXA0081636 —UN—15JUN05 SET LOCK SET OURX935,000000C 1903JAN081/1 Operator Presence Sensor Service Alert indicator light will flash with an audible warning signal if operator leaves seat with transmission in PARK or NEUTRAL and SCV control in ”Continuous” or ”Timed Detent” modes. will come on with an associated message appearing on the CommandCenter display. NOTE: SCV does not disengage when operator leaves seat.
After 5 seconds, Service Alert indicator and audible warning signal will stop, and Information indicator light OURX935,000000D 1903JAN081/1 607 122208 PN=154