Performance Ballasting General Guidelines for Tractor Weight Based on PTO Kilowatt The total tractor weight needed to efficiently deliver power through wheels to ground for field draft applications depends on travel speed. The table shows recommended weight per PTO kilowatt for three draft speed ranges. NOTE: It is recommended to use the radar to continually monitor wheel slip. Checking wheel slip manually is possible but will only show slip in one area of the field. Ground Speed 8.7 km/h (5.4 mph) and faster 7.2 8.7 km/h (4.5 5.4 mph) 7.2 km/h (4.5 mph) and slower Light Medium Heavy IMPORTANT:
To extend drive train life, tractor should never be operated with continuous fullpower loads below 6.4 km/h (4.0 mph). Ground speed may briefly drop below that level in hard pull situations, but it must recover to higher levels during normal operations. This applies to tractors with all types of transmissions. For tractors equipped with AutoPowr transmission operating in automatic mode, the engine will not labor in extremely high draft situations, but minimum ground speed guideline must still be followed. Kg/PTOkW 41 45 48 Lb/PTOHP 120 130 140 Wheel slip should normally be in the range of 812% for optimum power delivery efficiency at these field speeds.
Wheel slip may briefly rise above this range when tractor encounters a higher draft area in the field, but it should not stay there continuously. Add more weight to drive wheels if slip is excessive. If there is less than minimum percent slip, ballast should be removed, unless needed for stability. OURX935,0000532 1927MAR061/1 General Weight Split Guidelines Weight split requirements are based on type of implement or attachment being used. A primary consideration is to maintain sufficient weight on front and rear axles to provide stability and steering security under both field and transport conditions. Other factors as indicated in following tables must also be considered.
Trailers, Towed Slurry and Fertilizer Tanks Implements that place HIGH VERTICAL LOADS on the drawbar or are connected to a high hitch point such as Premium Wagon Hitch: MFWD and Independent Link Suspension Up to approximately 55% on front axle to insure steering security and stability. IMPORTANT: This split will vary depending on the application. If heavy drawbar load or hitchmounted implements are being used, INCREASE the weight on the front to insure stability and steering security. It may be practical to have a lower front percentage with smaller trailers, but steering security and stability must still be assured.
Towed Draft Implements Integral and SemiIntegral Implements Towed equipment that place SMALL VERTICAL LOADS on the tractor drawbar such as disks, chisel plows, and field cultivators: Implements that place LARGE VERTICAL LOADS on the hitch such as mounted rollover plows. MFWD No more than 35% on front axle. This is required for power hop control. (See Power Hop Control section for details.) MFWD and Independent Link Suspension Up to approximately 55% on front axle. Independent Link Suspension 40% up to approximately 55% on front axle. Best tractive performance is attained in lower end of range, but there is only a modest reduction in performance at higher values. CAUTION:
Do not exceed front tire carrying capacities when using high percentages of front weight. See Maximum Load Per Wheel in this section. BB92646,0000058 1919JUL051/1 752 122208 PN=179