John Deere Omar287594 — Ballast Types

Performance Ballasting Ballast Types Cast iron wheel weights and QUIK­TATCH weights are the preferred form of ballast. Liquid ballast in tires should be avoided if practical since it has a stiffening effect that causes rough ride and makes the tractor more susceptible to power hop. If liquid is used in rear tires, all tires on the axle must be filled to the same level which should not exceed 40% (4 o’clock valve stem position). Specific information on use of liquid ballast is given later in this section. RXA0082881 —UN—08AUG05 In some cases, it may be necessary or desirable to remove either front or rear ballast. A QUIK­TATCH weight facilitates this for front ballast.

Installation and removal of rear weights on outside of wheels requires the use of a hoist or forklift. Removal of inner rear wheel weights should not be required after initial installation at factory or dealership. Independent Link Suspension The standard front weight support mounted on a tractor equipped with Independent Link Suspension effectively ADDS 147% of its weight to the front axle and SUBTRACTS 47% of its weight from the rear axle due to leverage.

Front Axle Multiplier = 1.47 Rear Axle Multiplier = ­0.47 Standard Front Weight Support The standard front weight support ADDS 1.47 x 170 kg (375 lb) = 250 kg (551 lb) to the front axle and SUBTRACTS ­0.47 x 170 kg (375 lb) = ­80 kg (176 lb) from the rear axle. The standard front weight support weighs 170 kg (375 lb). MFWD The standard front weight support mounted on a tractor equipped with MFWD effectively ADDS 145% of its weight to the front axle and SUBTRACTS 45% of its weight from the rear axle due to leverage. The standard front weight support ADDS 1.45 x 170 kg (375 lb) = 247 kg (544 lb) to the front axle and SUBTRACTS ­0.45 x 170 kg (375 lb) = ­77 kg (169 lb) from the rear axle.

Front Axle Multiplier = 1.45 Rear Axle Multiplier = ­0.45 Continued on next page BB92646,0000059 ­19­05AUG05­1/5 75­3 122208 PN=180