John Deere Omar287594 — Using QUIK-TATCH Weights

Performance Ballasting Controlling Power Hop—MFWD Tractors Power hop causes tractor bouncing and/or jumping at field working speeds under 16 km/h (10 mph). It can occur when the tractor is pulling towed implements at medium to high draft loads in loose, dry soil on top of a firm base and/or when climbing hills. 2. Increase front inflation pressures by another 40 kPa (0.4 bar; 6 psi) and operate tractor. 3. Continue to increase front inflation pressures in 10 kPa (0.1 bar; 2 psi) increments up to a maximum of 40 kPa (0.4 bar; 6 psi) ABOVE maximum pressure rating for the tires (imprinted on tire sidewall).

Make adjustments ONLY after making sure the following performance guidelines have been followed: No more than 35% of the tractor weight on the front axle If liquid ballast is used in rear tires, it should not exceed 40% (4 o’clock valve stem position) Front and rear inflation pressures set correctly based on static loads. See Wheels, Tires, and Treads section. IMPORTANT: Front tire pressure should not exceed 40 kPa (0.4 bar; 6 psi) more than the maximum rated inflation pressure shown on tire side wall. If Power Hop Still Occurs: 4. Install up to 75% liquid in the front tires and remove an equivalent amount of front cast weight to maintain recommended weight split.

Re­inflate the front tires to the maximum pressure rating for the tires and operate the tractor. See Using Liquid Ballast in this section to determine exact amount of weight that will be added. Then if Power Hop Occurs: 1. Increase front inflation pressures by 40 kPa (0.4 bar; 6 psi). NOTE: In most cases step 4 will not be required to control power hop. If Power Hop Still Occurs: BB92646,000005C ­19­15JUL05­1/1 Using QUIK­TATCH Weights Up to 20 QUIK­TATCH weights can be installed on tractors. Install QUIK­TATCH weights, balanced on each side of center (C). The first two weights must be installed as a pair.

RXA0080130 —UN—06APR05 Run retaining bolts (A) through holes and secure with a nut to hold six weights or fewer in position. Tighten bolts. Weight Attaching Bolts—Specification Bolt—Torque.................................................................... 230 (170 lb­ft) Insert retainers between weights, one with threaded hole upward (B) and the other with threaded hole downward when eight or more weights are installed. Tighten bolts. A—Retaining Bolts B—Retainer with Hole Up C—Center Weight Attaching Bolts—Specification Bolt—Torque.................................................................... 230 (170 lb­ft) BB92646,000005D ­19­05AUG05­1/1 75­13 122208 PN=190