John Deere Omar287594 — Clamp-On Dual Usage

Front Wheels, Tires, and Treads Independent Link Suspension or 1500 MFWD Clamp On Dual Front Tire, Fender and Steering Stop Settings Tractors equipped with Independent Link Suspension (ILS) or 1500 MFWD axle are approved for limited use of clamp on front dual wheels. Clamp on duals are limited to two tire sizes, 540/65R34 and 600/70R30. Tread spacings available are in the table below. When using clamp on duals, all tread positions must use steering stop position 3. Tool Box must be moved from factory installed location to alternate right­hand location. See your John Deere dealer for details. NOTE: Listed below are instruction to use the Inner Wheel Tread Spacing Table. IMPORTANT:

Do not drive tractors equipped with duals faster than 40 km/h (25 mph). The first row under the heading identifies tread spacing in millimeters and inches. IMPORTANT: Any variance from tread settings listed below may damage fuel tank and/or steps. Column one provides tire size. The first number in column identifies an eight position rim is used. The first letter indicates which example to follow from the Eight Position Wheel Settings. The next number is the correct steering stop position. The last capital letter is the fender setting, taken from 1500 MFWD and Independent Link Suspension Fender Settings block in this OM.

If there is a “w” in the fifth position, it indicates the setting is for wide fenders. NOTE: To determine the mean setting, add tread spacing for inner tire (center to center) and tread spacing for outer tire (center to center). Divide by two. The mean tread setting cannot exceed 2794 mm (110 in.). Maximum ILS or 1500 MFWD static front axle weight, without liquid ballast or duals, is 10795 kg (23800 lb). OURX935,000023E ­19­21APR08­1/1 Clamp­On Dual Usage IMPORTANT: Clamp­on duals should not be used for heavy traction work. They are allowed only for use when the following conditions are met including recommended tire sizes and manufacturers.

Steel wheel­to­cast hub cap screws and washers are replaced with cap screws and washers contained in kit AR217153. Use rear wheel bolt tightening procedure (See Tightening Rear Wheel Bolts in this section). Inner single wheel tread setting does not exceed 1900 mm (75 in.). Outer dual wheel tread setting does not exceed 3400 mm (134 in.). Average tread width of dual combination does not exceed 2650 mm (104 in.). Outer tire must be of equal or smaller section width tire. Drive wheels and clamp­on dual tires should be inflated to the same pressure. IMPORTANT: Do not drive tractors equipped with duals faster than 40 km/h (25 mph).

Clamp­on dual wheels are used only in low draft or PTO applications. Maximum vehicle weight is limited to 16000 kg (35274 lb). Rear drive wheel is heavy duty cast center type. Current wheel sleeve cap screws and washers are replaced with cap screws and washers contained in kit AR219840 for cast drive wheel. OURX935,00002A1 ­19­23NOV07­1/1 80­22 122208 PN=217 Inner Wheel Tread Spacing 1780 mm (70 in.) 1882 mm (74 in.) 1979 mm (78 in.) 2080 mm (82 in.) Tire Size Independent Link Suspension Axle 540/65R34 8C3B 8D3C 8F3D 8G3E 600/70R30 N/A 8L3C 8N3D 8O3E 1500 MFWD Axle 540/65R34 8C3Bw 8D3Cw 8F3Dw 8G3Ew 600/70R30 N/A 8M3Cw 8N3Dw 8O3Ew