Fuels, Lubricants, and Coolant John Deere COOLGARD™II COOLANT EXTENDER Some coolant additives will gradually deplete during engine operation. For John Deere COOLGARD™II Premix and COOLGARD II Concentrate, replenish coolant additives between drain intervals by adding John Deere COOLGARD II COOLANT EXTENDER. IMPORTANT: Do not add a supplemental coolant additive when the cooling system is drained and refilled with any of the following: John Deere COOLGARD II John Deere COOLGARD John Deere COOLGARD PG John Deere COOLGARD II COOLANT EXTENDER should not be added unless indicated by coolant testing.
John Deere COOLGARD II COOLANT EXTENDER is a chemically matched additive system approved for use with John Deere COOLGARD II coolants in all John Deere engines. The use of nonrecommended supplemental coolant additives may result in additive dropout, gelation of the coolant, or corrosion of cooling system components. Add the recommended concentration of John Deere COOLGARD II COOLANT EXTENDER. DO NOT add more than the recommended amount. John Deere COOLGARD II COOLANT EXTENDER is not designed for use with John Deere COOLGARD coolants.
COOLGARD is a trademark of Deere & Company DX,COOL16 1903NOV081/1 Operating in Warm Temperature Climates John Deere engines are designed to operate using glycol base engine coolants. IMPORTANT: Water may be used as coolant in emergency situations only. Always use a recommended glycol base engine coolant, even when operating in geographical areas where freeze protection is not required. Foaming, hot surface aluminum and iron corrosion, scaling, and cavitation will occur when water is used as the coolant, even when coolant conditioners are added. John Deere COOLGARD™II Premix is available in a concentration of 50% ethylene glycol.
However, there are situations in warm temperature climates where a coolant with lower glycol concentration (approximately 20% ethylene glycol) has been approved. In these cases, the low glycol formulation has been modified to provide the same level of corrosion inhibitor as John Deere COOLGARD II Premix (50/50). Drain cooling system and refill with recommended glycol base engine coolant as soon as possible. COOLGARD is a trademark of Deere & Company DX,COOL6 1903NOV081/1 909 122208 PN=245