250 Hour Service Lubricating Independent Link Suspension Axle—External Fittings RXA0056573 —UN—30AUG01 RXA0056575 —UN—30AUG01 A—Upper Control Arm Fittings B—Lower Control Arm Fittings C—Kingpin Fittings D—Suspension Cylinder Fittings E—Tie Rod Fittings Use John Deere SD Polyurea grease or other grease as specified in Fuel, Lubricants and Coolant section. Suspension Cylinders —Lubricate fittings (D) for both ends of each suspension cylinder. Upper Control Arms —Lubricate fittings (A) on each side of suspension. Tie Rods —Lubricate fittings* (E) for each tie rod. Lower Control Arms —Lubricate fittings (B) on each side of suspension.
* Daily or 10 Hours in extremely wet conditions or where Auto Trac is used Kingpins —Lubricate fittings* (C) for each kingpin bearing. OURX935,00002BD 1913AUG081/1 Lubricating MFWD Axle RXA0098557 —UN—16JUN08 A—Kingpin Fittings, Bottom B—Tie Rod Fittings C—Steering Cylinder Fittings D—Axle Pivot Fittings E—Kingpin Fitting, Top, Right Side F—Kingpin Fittings, Top, Left Side Kingpins, Tie Rods and Steering Cylinder Use John Deere SD Polyurea grease or other grease as specified in Fuel, Lubricants and Coolant section. In extremely wet conditions or where AutoTrac is used, service daily or every 10 Hours. Tie Rods —Lubricate fittings (B). Steering Cylinder —Lubricate fittings (C).
Axle Pivot —Lubricate front and rear fittings (D). Kingpins —Lubricate fittings (A, E, and F) until grease appears at orifice on bottom end of each kingpin bearing. OURX935,0000453 1905AUG081/1 1025 122208 PN=265