John Deere Omar287594 — Checking MFWD or Independent Link Suspension Wheel Hub Oil Level

250 Hour Service Check Tow­Hook on Pick­Up Hitch for Wear CAUTION: Parts that have reached or exceeded their wear limit must be replaced with new parts. Check gap (A) at catch. Specification Gap at catch—Maximum permissible clearance...................................................... 10.0 mm 0.39 in. RXA0095866 —UN—29AUG07 Read the (unit of measurement = kN) from pick­up hitch type plate. If the “D”­value indicated on the type plate is 65 or less, observe the following wear tolerances (A). Specification Tow hook, diameter (D = 65 or less)—Minimum value (A), diameter 1....................................................................................... 43.5 mm 1.71 in.

Minimum value (A), diameter 2........................................ 42.0 mm 1.65 in. Minimum value (A), diameter 3........................................ 40.5 mm 1.59 in. If the “D”­value indicated on the type plate is greater than 65, observe the following wear tolerances (A). LX1041808 —UN—27NOV06 Specification Tow hook, diameter (D = more than 65)—Minimum value (A), diameter 1....................................................................................... 45.0 mm 1.77 in. Minimum value (A), diameter 2........................................ 43.5 mm 1.71 in. Minimum value (A), diameter 3........................................ 42.0 mm 1.65 in.

A—Gap OURX935,000032E ­19­12JUN08­1/1 Checking MFWD or Independent Link Suspension Wheel Hub Oil Level Put the tractor on level ground. Turn wheel hubs until the words OIL LEVEL are horizontal. Remove plug (A). Oil level should be just below plug hole. If low, add oil through same hole. RW26335 —UN—25JUN99 John Deere GL­5 Gear Lubricant is recommended. A—Plug OURX935,0000335 ­19­19JUN08­1/1 102­12 122208 PN=272