John Deere Omar287594 — Draining, Flushing and Refilling Cooling System

2000 Hour Service Adjusting Engine Valve Clearance See your John Deere dealer for correct engine valve clearance. OURX935,000030A ­19­12JUN08­1/1 Draining, Flushing and Refilling Cooling System IMPORTANT: Thermostats and de­aeration tank cap should be replaced whenever system is flushed. INITIAL change interval is 6 years or 6000 hours, provided cooling system is topped off using only John Deere Cool­GARD II and premix and coolant is tested at recommended intervals. After initial service, the SCHEDULED interval (2 years or 2000 hours) can be extended up to 6 years or 6000 hours depending on coolant used and if coolant is tested at recommended intervals.

Follow recommendations in “Drain Intervals for Diesel Engine Coolant” in Fuels, Lubricants and Coolant section of this manual. COOL­GARD™ TS281 —UN—23AUG88 Check de­aeration tank level. If tank is empty and recovery tank has been kept at least full cold, this indicates a leak that prevents system from recovering coolant from recovery tank. If recovery tank level does not change when engine is being warmed up, this is a sign of a leak or of a very low coolant level in the pressurized circuit. CAUTION: Explosive release of fluids from pressurized cooling system can cause serious burns. Shut off engine. Only remove cap when cool enough to touch with bare hands.

Slowly loosen cap to first stop to relieve pressure before removing completely. After flushing system, cooling system should be checked for leaks and de­aeration cap should be pressure checked. See your John Deere dealer for testing. COOL­GARD is a trademark of Deere & Company Continued on next page OURX935,00004A7 ­19­12DEC08­1/6 107­1 122208 PN=291