2000 Hour Service 20. Start engine and run at a minimum of 1500 rpm for 15 minutes. CAUTION: Explosive release of fluids from pressurized cooling system can cause serious burns. Shut off engine. Only remove cap when cool enough to touch with bare hands. Slowly loosen cap to first stop to relieve pressure before removing completely. TS281 —UN—23AUG88 21. Shut off engine and allow to cool. 22. Open hood, remove deaeration cap, put drain pans in place, then open radiator and engine drain valves. Remove EGR cooler vent plug. NOTE: For tractors equipped with Automatic Temperature Control, temperature readout must say and key must be in RUN position.
This prevents trapping cleaning solution in the heater. CAUTION: Explosive release of fluids from pressurized cooling system can cause serious burns. Shut off engine. Only remove cap when cool enough to touch with bare hands. Slowly loosen cap to first stop to relieve pressure before removing completely. 23. For tractors with ATC, Start engine and turn ATC to High. When High is displayed on readout, turn off engine and finish draining system. 27. Turn off engine, allow coolant to cool, then using previously listed steps, drain system. 24. Install radiator and engine drain plugs. 25. Using clean water, begin filling coolant system.
When air is purged and water appears at the EGR port, install EGR cooler vent plug and finish filling the system. 28. Close engine drain valve and radiator drain valve. 29. Begin filling system with proper mix of coolant and distilled water or demineralized water. When air is purged and water is visible in the EGR valve port, close EGR cooler vent plug. CAUTION: Make sure fan guard and side panel are installed and hood is closed before starting engine. CAUTION: Make sure fan guard and side panel are installed and hood is closed before starting engine. 26. Close hood, start engine and run for a minimum of 1500 rpm for 15 minutes.
Continued on next page OURX935,00004A7 1912DEC084/6 1074 122208 PN=294