John Deere Omar287594 — Back Flushing the Optional Fuel Water Separator—If Equipped

General Services 15. Pull or gently pry belt (A) onto drive shaft (B) and against rear pulley. 16. Replace any damaged roll pins. IMPORTANT: When installing front pulley (C), make sure that belt remains loose and is not pinched between pulleys. RXA0079205 —UN—22FEB05 A Clean mating surfaces of front pulley and shaft. B 17. Install front pulley making sure roll­pins (D) align with holes in pulley and shaft. 18. Hold front drive pulley with wrench and tighten cap screw (E) to specification. Install Belt Drive Pulley­to­Drive —Specification Cap Screw—Torque ........................................................ 375 (276 lb­ft) A C D E 19.

Check bleed screw to make sure that it is closed and belt is loose between pulleys. RXA0085953 —UN—18JAN06 D 20. Install diverter panel and right­hand side front shield and torque to specification. Diverter Panel Cap Screws —Specification Cap Screw—Torque ........................................................ 20 (15 lb­ft) Install Front pulley NOTE: Starting engine with belt loose between pulleys allows belt to climb out of groove between pulleys. Belt will correctly position itself within a few seconds after engine is started. A—Belt B—Drive Shaft C—Front Pulley D—Roll­Pins (3 Used) E—Cap Screw 21. Start engine and run at idle for 15 seconds. Turn off engine. 22.

Remove right­hand side front shield and make sure that belt is correctly positioned between pulleys. CAUTION: Keep hands away from exposed fan blades. Blades have sharp edges which may result in personal injury. 23. Install right­hand front side panel. OURX935,000050F ­19­16SEP08­3/3 Checking Weep Hole 1. Remove left­hand side panel. 2. Inspect weep hole (A) for oil or coolant leakage. Oil leakage indicates a damaged rear seal. Coolant leakage indicates a damaged front seal. If leakage is detected, see your John Deere dealer to replace complete coolant pump assembly (repair parts are not available).

RXA0082662 —UN—28JUL05 A—Weep Hole Coolant Pump Weep Hole OURX935,0000312 ­19­12JUN08­1/1 110­8 122208 PN=305