John Deere Omar287594 — HID Bulbs

Electrical Services Handling HID Light Bulbs Safely CAUTION: Handling a bulb improperly could cause it to shatter into flying fragments. To avoid possible injury: High voltage is conducted by electrical connection between worklights and ballast unit; this connection must never be broken. Handle bulb by its base. Keep bulb oil free; wear gloves to avoid touching glass. Use a clean cloth and alcohol to remove any fingerprints from the glass bulb before installing. Skin oil deposited on bulb will cause overheating and premature failure. Do not operate bulb outside of enclosure.

When operating, HID bulbs have high internal pressure and if they are cracked or broken, they could explode and cause injury. Turn light switch off and allow bulbs to cool before changing. Leave switch off until bulb change is done. TS266 —UN—23AUG88 Wear eye protection. Do not drop or scratch bulb. Keep moisture away. Place used bulb in the new bulb carton and dispose of properly. Keep out of reach of children. OURX935,000031B ­19­12JUN08­1/1 HID Bulbs Front HID Bulb Replacement: CAUTION: Wear gloves and safety glasses when handling bulbs. Dangerous voltage spark­over may occur and cause damage/injury at the connector. See manufacturer warning packaged with replacement bulb. 1.

Disconnect wiring harness from HID assembly. 2. Press in on HID assembly (A) and remove retainer (B) using a screwdriver. RXA0082294 —UN—12JUL05 A—HID Assembly B—Retainer Front HID Bulb Replacement Continued on next page OURX935,000031C ­19­12JUN08­1/2 120­5 122208 PN=315