John Deere Omar287594 — Replacing Cab Roof Hazard Light Bulbs

Electrical Services Aiming Head Lights C D RXA0086628 —UN—13FEB06 E B A 7.5m (25 ft) A—Head Lights B—Distance from Center of Head Light to Ground C—Horizontal Line on Wall D—Border of Bright Area E—10% of Distance (B) 1. Park tractor on a level surface with head lights (A) 7.5 meters (25 ft) from a vertical wall. 4. Set head lights on low beam and observe bright areas on the wall. 2. Measure the distance (B) from the center of a head light to the ground. 5. Adjust head lights so the upper border of bright area (D) is at least one tenth of distance (B) below line (C). 3. Mark a horizontal line (C) on the wall, at the same distance from the ground as (B).

OURX935,000031E ­19­12JUN08­1/1 Replacing Front Belt­Line, Cab Roof Rear and Side or Rear Fender Flood Light Bulb 1. Rotate flood light as necessary, to access backside of light. 2. Belt­line and rear fender flood lights; Remove rubber cover. A RXA0068500 —UN—09SEP03 3. Disconnect wiring harness plug (A). 4. Rotate bulb (B) counterclockwise approximately 1/4 turn and remove. B 5. Install bulb in reverse order of removal. Rear Cab Roof Flood Light Shown A—Wiring Harness Plug B—Bulb OURX935,000031F ­19­12JUN08­1/1 120­7 122208 PN=317