EVERY 500 HOURS SERVICE b. TRANSMISSION OIL FILTER c. FAN BELT Check the V-belt and when the fol- lowing conditions exist, exchangethe belt: WhentheV-beltmakescontactwith the bottom of the groove in each pulley. When the V-belt is worn, and its surface is lower than the outer When cracking and peeling of the diameter of the pulley. Remove the side panel. When tightening center bolt (3), V-belt occurs. tom of the filter case, and drain the Remove drain plug (I) at the bot- (4) of the washer faces the hexago- install so that chamfered surface the plug. oil. After draining the oil, tighten Run the engine for a short time at nal head of the center bolt. bolt (31, then remove case (2).
Hold case (2) and loosen center Check that the oil is at the specified idling speed, then stop the engine. Remove the element, and clean the level (for details, see WHEN RE- element, then install the case. inside of the case. Assemble a new QUIRED). Use a genuine Komatsu element. torque to center bolt (3). Be careful not to apply excessive Replace the filter gasket and O- rings with new parts. Coat the Tightening torque: 18.5 f 1.5 kgm gasket and O-rings with clean engine oil before installing. - IOI-