Komatsu — EVERY 500 HOURS SERVICE

EVERY 500 HOURS SERVICE l Replacement d. LUBRICATING Exchange V-belt as follows: shown by arrow. Apply grease to the grease fitting 1. Center drive shaft spline (1 point) Insert a bar about 500 mm in length sion pulley bracket and pull for- into the hole (918 mm) of the ten- ward strongly. The spring tension loosens and the tension pulley moves inward, so In the same way, install a new belt. remove the old belt. When changing belts, do not only change one belt. Always change as a set. - 102-