EVERY 2000 HOURS SERVICE c. HYDRAULIC TANK BREATHER Use the same procedure to change the oil for the front and rear axles. Refill capacity: 1 10 R (each axle) The type of lubricant used depends on the ambient tempera- ture. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. 1 Remove cap of oil filler. A When removing the cap, turn it slowly to relieve inner pressure. 3. Replace filter element with a new part, then install cap and snap ring. * It is possible to replace the ele- ment with the breather installed in the tank. However, if the breather is removed, do not wrap 2. Remove snap ring on breather (I 1, then remove breather cap.
the taper thread of the breather with seal tape when assembling again, and be careful not to tight- en too much. W-03742 -lll-