Komatsu — EVERY 2000 HOURS SERVICE

EVERY 2000 HOURS SERVICE d. ENGINE BREATHER e. AIR CONDITIONER FILTER f. TURBOCHARGER ROTOR PLAY Contact your Komatsu distribu- tor for checking, or proceed as follows: Remove air intake pipe from turbocharger. I. Axial play Check axial play by moving rotor in axial direction. Play: Standard 0.08 - 0.18 mm Radial play Measure radial play by moving rotor holding both ends by hands in radial direction in parallel. Play: Standard 0.25 - 0.60 mm 1. 1. O’pen the cover located on the behind of the operator’s seat. Loosen nut (I) holding the filter element, pull out element (2). Install a new element and close the cover. 2.

Remove the bolt, take breather out of place and wash element (I) in clean light oil to remove dust from it. After cleaning, fill with clean fuel. After cleaning, dry fuel with air. 2. 2. 3. * 3. * If the play is over the limit, consult your Komatsu distributor. If the rotor is excessively soiled with dust or carbon or if any oil leakage caused by turbocharger trouble is noted, have the tur- bocharger repaired by your Komatsu distributor. Before removing the breather, clean around the breather to remove the dirt. Replace the O-rings with new parts. Coat the O-rings with clean engine oil before installing. * * - 112-