WHEN REQUIRED Drain plug (cylinder block) Drain plug (torque converter cooler) 11. Repalce the corrosion resistor cartridge and open corrosion resistor valve (1). * For details of replacement of the corrosion resistor, see EVERY 1000 HOURS SERVICE. 12. the water filler. Supply water up to the vicinity of 13. Run the engine.fbr :5;minut& at lowidlingtoeliminateairtrapped in the.ccioling system,, and run the Afterdrainingwater,useaflushing agent to clean. 9. cinity of the water filler, put the When the water reaches the vi- enginefor5’minutesat high idling.
(leave water filler cap (2) off dur- genuine goods as the flushing We recommendthe use of Komatsu valve (3) and plug (41, then pass engine at low idling, open drain 14. Stop the engine and 3 minutes ing this operation.) agent. Follow the instructions on water through the cooling sys- later supply water again up to clean the system. the label of the flushing agent to tem until clean water comes out from drain valve (31, plugs (4) and vicinity of the water filler and tighten water filler cap (2). After washing the cooling system, drain off all the water, then close -k When doing this, adjust the in- (5).
up drain valve (3), plugs (4) and (5), flow and outflow of water so that water)uptothevicinityofthewater and pour in soft water (ex: city 10. When the water becomes com- the radiator is always full. filler. close drain valve (3), plugs (4) and pletely clean, stop the engine, (5). -118-