WHEN REQUIRED The type of lubricant used depends on the ambient temperature. Se- lect according to the table “FUEL, CLEAN RADIATOR FINS Carry out this procedure if there is any mud or dirt seen stuck to the radiator. e. CHECK AND REFILL AXLE OIL Carry out this procedure if there is any sign of oil on the axle case. COOLANT AND LUBRICANTS”. Stop the engine when checking the oil level. Make an oil level check beforestart- ing engine or ,I5 minutes or more after the engine is stopped. If oil remains at various portions, the correct oil level cannot be meas- ured. A When checking the oil level, apply Front the parking brake, and lock the front and rear frames with the safety bar and pin. 1.
Loosen bolt (1) and remove radia- tor grille (2). 2. Clean the radiatorfinsand oil cooler fins clogged with mud, dust and leaveswith compressed air. Steam or water may be used instead of compressed air. * The rubber hoseshould bechecked at the same time. If the hose is found to have cracks or to be hard- ened by ageing, such hose should be replaced by new one. Further, loosened hose clamp should also be checked. - 122- Removeoillevelplug(l),andcheck thattheoil level reachesthe bottom of the plug hole. If necessary, add oil through the hole of plug (1).