Komatsu — WHEN REQUIRED

WHEN REQUIRED The following methods require spare C. SION OIL CHECK AND REFILL TRANSMIS- With water parts. any sign of oil on the transmission Carry out this procedure if there is on element from inside along folds, Dash city water (less than 3 kg/cm*) case, or if there is oil mixed with the then from outside and again from cooling water. inside. Dry and check it. With cleaning agent For removing oils and fats as well as carbon etc. attached on the ele- ment, the element may be cleaned in lukewarm solution of mild detergent, found on element when it is If small holes or thinner parts are then rinsed in clean water and left to drip dry.

checked with an electric bulb after cleaning and drying, replace the Drying can be speeded up by blow- element. Stop the engine and remove the 7 kg/cm*) from the inside to the ing dried compressed air less than gasket or seal are damaged. Do not use element whose folds or cap of oil filler (F). Use dipstick (G) to check the oil outside of the element. Never attempt to heat the element. When cleaning element, do not hit it or beat it against something. The oil level should be between level. Using warm water (about 40°C) instead of soapywater may also be at the oil filler (F). mark Land H, if necessary, add oil effective. - 121-