WHEN REQUIRED k. CLEAN AXLE CASE BREATHER Carry out this procedure if there is any mud or dirt stuck around the breather. I. CHECKING OF APS (automatic priming system) Checking is performed in autumn (when the ambient temperature is below 15°C). Front Rear 1. Open fuel valve (I 1 of automtic priming system, and remove hose (2) at entrance of nozzle. 2. Move feed pump (3) up and down, and bleed air until air bub- bles stop coming out of opening of hose (2). Remove all mud and dirt from around the breather with brush. Then, remove breather, immerse in cleaning fluid and clean. Sr Clean the breathers of the front and rear axles in the same way.
* Do not let dirt get into the port while breather is removed. * If dust sticks to area around breather, clean with a brush. Perform the next test the same way. l Is there a fuel leak? l Is the fuel piping plugged? W-03756 - 127-