Komatsu — WHEN REQUIRED

WHEN REQUIRED m-DRAIN WATER FROM WATER SEPARATOR 3. After putting preheater switch in When float (2) is at or above red 3. If the air is sucked into fuel line to auto, check the following the following procedure: bleed air in the same manner as ON position and after returning line (I 1, drain the water according to when drain the water, be sure to items: 1. Loosen drain plug (3) and drain for the fuel filter. l Does the pre-heat monitor lamp turn off after about 80 seconds? 2. the accumulated water until the (See Fuel Filter Cartridge in float reaches the bottom. EVERY 500 HOURS SERVICE l When the pre-heat monitor lamp turns off, are the glow plugs (2 pieces) red hot?

When hand is removed from preheater switch when in ON po- sition, switch will return to AUTO position automatically. Tighten drain plug (3). section.) * - 128-