BLEEDING AIR FROM CIRCUIT BLEEDING AIR FROM CIRCUIT BLEEDING AIR FROM HYDRAU- LIC CIRCUIT BLEEDING AIR FROM BRAKE HYDRAULIC CIRCUIT l After replacing oil,filter element or strainer, bleed the air from the cir- cuit. To bleed the air from the hydraulic cylinders or hydraulic piping, run the engine at low idling and do asfollows. 1) Operate each hydraulic cylinders 4 to 5 times, stopping 100 mm from stroke end. 2) Next, operate each cylinder 3 to 4 sr times to the stroke end. If the engine is run at high speed at first, or if the cylinder is moved to the end of its stroke, the air in the cylinder may damage the piston packing, etc. After removing piping of brake 3.
Repeat until air bubbles stop coming out of air bleeder plug (A). After bleeding air, close plug and hydraulic circuit, air bleed the inside of the circuit as follows: Ir Afterassemblingthepiping,besure to check that the connectors are * fit cap. Bleed air at 4 locations. After bleeding air, check the oil level in the brake oil tank. If it is insufficient, add engine oil. not loose. sr 1. Remove the cap of air bleeder plug (A). 2. Depress brake pedal, loosen air A , Always use engine oil to refill the bleeder plug (A) about 314 of a turn & and after closing plug, release brake oil tank. pedal. -84-