Komatsu — PRECAUTIONS FOR MAINTENANCE

PRECAUTIONS FOR MAINTENANCE Greasing the rod end Because of the rod end is the oil- less type, no greasing is required, al- though a grease nipple is fit to the rod end on the lever linkage. The rod end should be greased only when it becomes stiff after using it for a long span of time. l When working in a dusty location, be careful of the following: I) Inspect the dust indicator to see whether the air cleaner is blocked up. Clean the air cleaner as soon as it becomes dirty. 2) Clean the radiator core so that it does not become blocked up. 3) Clean or replace the fuel filter as soon as it becomes dirty.

4) Clean the electrical equipment, 0 After disconnecting the connec- tor, cover it with a vinyl bag to prevent oil or dust from sticking to its contact section. When welding, be careful of the following: Turn OFF the power (starting 0 1) 2) switch). Do not continuously apply more than 200 V. Install the ground cable at least 1 m from the range to be welded. Take care not to install the seals between the grounded point and the range to be welded. Use ordinary automobile washer fluid. Be careful not to let dirt or dust get in. 3) particularly the starting motor and alternator, to prevent ac- cumulation of dust.

When installing car radio and a walkie-talkie or citizen band, con- tact your Komatsu distributor. When washing the machine, take care not to splash water over the electrical equipment. if it is soaked with water, it may not operate normally. 4) Ir 0 0 W-02237 - 83 -