EVERY 250 HOURS SERVICE c. ALTERNATOR BELT 1. The belt tension should normally deflect by about 10 to 15 mm when pressed with the finger at a point midway between the alter- nator pulley and the drive pulley (approx. 6 kg). 2. To adjust the belt tension, loosen bolt (I 1 and nut (2) and shift alter- Sr When adjusting the V-belt, do not attempt to push alternator (3) directly with a bar or the like, but use a wood pad to prevent damage to the core. * Check each pulley for damage, and V-grooves and V-belt for wear. Particularly, check whether V-belt is in contact with bottom of V-groove through wear.
Sr Replace belt if it has stretched, leaving no allowance for ad- justment, or if there is a cut or crack on belt. nator (3) slightly. 3. After adjustment, tighten bolt (1) and nut (2) securely. Ir After operating the machine for one hour with a newly exchanged V-belt, test and adjust the V-belt again. W-03728 -97 -