EVERY 250 HOURS SERVICE d. WHEEL HUB NUTS e. FUEL FILTER f. AIR CONDITIONER COMPRESSOR BELT If wheel hub nuts (I) are loose, tire wear will be increased ands acci- dents may be caused. If any hub nuts are loose, tighten them to the specified tightening torque. * Tightening torque: 84 + 9 kgm * If any wheel‘nut is broken, replace all nuts for that wheel. * Always rotate in the direction of tightening when checking for loose nuts. Loosen the air bleeding plug and remove the drain plug on the bottom of the filter to drain water and sediment accumulated on the bottom of the fuel filter. (At two filters) After draining, move the feed pump up and down to bleed air.
When no air bubbles come out of the air bleeding plug hole, tighten the plug. 1. The belt tension should normally deflect by about 10 mm when pressed with the finger at a point midway between the air condi- tioner compressor pulley and the drive pulley (approx. 6 kg). - 98 - w-93129