Chassis Module and Expansion Module 54.13 General Information General Information The Chassis Module (CHM) and the Expansion Mod- ule (EXM) both serve the same function in the M2 electrical system by acting as slaves to the Bulkhead Module (BHM). The CHM and EXM respond to com- mands from the BHM and broadcast the status of the inputs and outputs that are sent to and delivered by the modules. 3 4 2 A Business Class M2 vehicle will always have a Chassis Module, but will only have an Expansion Module when optional features require it. The CHM and EXM both have five harness connectors, though they may not all be used.
Chassis Module 5 The CHM is usually mounted on the left frame rail, aft of the cab. See Fig. 1 . The CHM is available in two configurations depending on the vehicle options: 09/28/2001 f543919 1 1. Chassis Module 2. Left Frame Rail 3. Cab Backwall 4. Crossmember 5. Driveline standard Chassis Module full Chassis Module The vehicle will have either a standard CHM or a full CHM, but not both. The standard CHM uses only the C1, C3, and C4 harness connectors. The remaining harness connectors are sealed. See Fig. 2 . Fig. 1, Chassis Module Installation on Frame Rail 1 Both the standard CHM and full CHM are supported by one version of software.
Alternate Mounting Location of the CHM 2 On some M2 vehicles the CHM is factory installed under the cab instead of on the frame rail behind the cab. This alternate location affects the C5 connector on the CHM, which controls any air management unit (AMU) solenoid that the vehicle may be equipped with. 5 3 4 When the CHM is mounted on the frame rail behind the cab, the harness for the AMU solenoids plugs directly into the C5 connector on the CHM. When the CHM is factory installed under the cab, a jumper loom is required between the plug coming from the AMU solenoids and the C5 connector on the CHM. 09/11/2001 f543900 1. C1, Taillight Harness 2. C2, Trailer Module Harness, Full CHM Only 3.
C3, Forward Chassis Harness 4. C4, Forward Chassis Harness 5. C5, Air Management Unit Harness, Full CHM Only The jumper loom is part of the forward chassis har- ness that is used with the CHM when it is factory installed under the cab. The jumper loom has generic circuit numbers and is present regardless of whether or not the AMU circuits are used on the vehicle. Fig. 2, Chassis Module Harness Connectors NOTE: See Specifications 400 for information on how a factory-installed CHM under the cab affects the wiring. Business Class M2 Workshop Manual, Supplement 10, September 2006 050/1