mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Chassis Module and Expansion Module 54.13 General Information Awake State and Sleep State Expansion Module The BHM, CHM, and instrumentation control unit (ICU) are, as a group, in an awake state or a sleep state depending on vehicle conditions. When any of these electronic components are awakened, the re- maining components wake up if they are not already awake. When the BHM, CHM, and ICU are in an awake state, the odometer reading appears on the dash driver display screen. The EXM is mounted on the aft chassis. Only one Expansion Module is available on a vehicle. See Fig. 3 for an illustration of the Expansion Module. NOTE:

The harness connector numbers on the CHM and EXM are the same since the hard- ware for the two modules is the same. However, the harness connector names for the CHM and EXM are not the same since the connectors on the EXM serve different functions than the con- nectors on the CHM. One of the following actions will cause the BHM, CHM, or ICU to go into an awake state:

opening the door switch turning on the hazard switch turning the ignition switch to any position other than off turning on the headlight/parking light switch depressing the service brake The BHM, CHM, and ICU will enter a sleep state when they are no longer actively controlling any out- puts or responding to any inputs and all other power down requirements are met. To check whether or not the electrical system is going into a sleep state: 1. Enter the vehicle. 2. Shut the doors. 03/09/2006 f543900a 3. Remove your foot from the service brake. Fig. 3, Expansion Module Harness Connectors 4. Make sure the ignition switch and hazard switch are in the off position. NOTE:

One minute after these conditions are met, and provided that one of the parameters in Table 1 has not been added to the BHM, the odometer reading should disappear. If the odometer reading does not disappear, the elec- trical system is not going to sleep. The EXM configuration uses external strapping. Ex- ternal strapping is a process that assigns a unique, predefined J1939 Source Address and J1587 Mes- sage ID to the module, which is viewable in Service- Link ® .

Parameters Parameter Part Number Description Hours 26-01017-002 Switched Center Pin Power 24 26-01019-003 Exterior Lighting 16,667 26-01019-004 Exterior Lighting 16,667 26-01019-005 Exterior Lighting 16,667 Table 1, Parameters Business Class M2 Workshop Manual, Supplement 10, September 2006 050/2